-MDS Custom engine, 0km after rebuild
-Garret motorsport turbo, inconel (Not latest spec)
-Inconel exhaust manifold, Fresh air system
-Almost new Tilton carbon clutch
-UNIC Transmission with realese, 0km after service
-UNIC driveshafts and joints, Tripod with 60mm plunge ,front and rear, 0km after service
-Motec M150 ECU
-Motec C127 dash
-Öhlins suspension, TPX front, TTX rear, long travel, 0km after service
-Aluminium uprights, McPehrson front, double A-arms rear
-Alcon brakes, front(345x28mm) and rear (295x25mm)
-PWR cooler and intercooler
-Light weight and built for very low center of gravity
-ATL fueltank, FIA approved until 2027
-Built 2018
-Renault Sport chassi
-1 Owner
Spareparts, moulds and jigs:
-Jigs for antirollbars, front and rear
-Jigs for subframe, front and rear
-Jigs for A-arms, rear
-Jig for toe bar, rear and caster bar, front
-Moulds for bumpers, front and rear, fenders, front and rear, hood, headlight covers, protection skin for left door, inner wheelarches, protection under frontbumper
-Water pump
-Oilfilter housing + filter
-Windscreen wiper motor
-Air filters x11
-Sump guard, front
-Steering rack + rods x4
-Antirollbar, rear x4, front x3
-Controlarm, front x2
-Toe bar, rear x2
-Caster rod, front x2
-A-arm upper, rear x3
-A-arm lower, rear x4
-Upright, front, left and right, including UNIC wheel bearings
-Upright, rear, left and right, including UNIC wheel bearings
-Brakecalipper, front and rear
-Brakedisc, front (345x28mm)x3 rear (295x25mm) x2
-Öhlins dampers, front and rear
-Downpipe
-Alternator
-Used rear subframe
-Rims x10
Bodyparts new and used:
-Rightdoor
-Front bumper x2
-Rear bumper x2
-Front fender, left x3
-Front fender, right x2
-Rear fender, right
-Protectionskin, left door x2
-Innerwheel arch x4
-Protection under front bumper
-Diffuser x2
Sweden
Get directions